Towerpro MG90S Metal Gear 360° Continuous Rotation Micro Servo
Prices updated: 13 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 EkostraCheapest | MG90S Mini Digital Servo Motor 180° 2.2kg | 160 EGP180 | View in store |
 RAM Electronics | MG90S Micro Servo Motor 360° 2.2 kg.cm Metal Gears | 165 EGP | View in store |
 Makers Electronics | MG90S Micro Servo Continuous Rotation 360 Degree (Full Metal Gear ) | 165 EGP | View in store |
Price history
Lowest daily price, last 90 days
Lowest price recorded: 160 EGP
About this product
The MG90S is a micro servo with metal gears that rotates continuously in both directions instead of holding a set angle. It suits small robots, wheeled platforms and mechanisms that need continuous motion. It is controlled with a standard PWM signal from any servo library, and it includes one bearing for added durability.
Specifications
- Rotation
- 360° continuous
- Gear type
- Metal gear
- Operating voltage
- 4.8 V – 6 V
- Stall torque
- 1.8 kgf·cm at 4.8 V; 2.2 kgf·cm at 6 V
- Weight
- 13.4 g
- Dimensions
- 22.5 x 12 x 35.5 mm (approx.)
- Bearings
- 1 bearing
Frequently asked questions
What is the price of Towerpro MG90S Metal Gear 360° Continuous Rotation Micro Servo in Egypt?
Towerpro MG90S Metal Gear 360° Continuous Rotation Micro Servo currently costs between 160 and 165 EGP across 3 offers in Egypt.
Where can I buy Towerpro MG90S Metal Gear 360° Continuous Rotation Micro Servo in Egypt?
Towerpro MG90S Metal Gear 360° Continuous Rotation Micro Servo is available from Ekostra, RAM Electronics, and Makers Electronics. Compare the offers above to find the best price.
How do I control a continuous rotation servo from an Arduino?
Use the standard Servo library. On a continuous rotation servo the pulse width sets direction and speed instead of an angle. A pulse near 1.5 ms usually means stop, but the centre point may need trimming on each unit.
Can I power it directly from the Arduino 5V pin?
The rated range is 4.8 V to 6 V and the stall current can be high under load. For more than one servo or heavy loads, use a separate regulated 5 V to 6 V supply and connect its ground to the Arduino ground.
