NTC 100K B3950 Thermistor 1% with 1m Cable and 2-Pin Connector
Prices updated: 12 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 Microohm | B3950 NTC 100K Thermistors 1% with 1000mm Cable and 2pin 2.54mm Terminal | 45 EGP60 | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 45 EGP
About this product
A 100 kΩ NTC thermistor with a B3950 characteristic and ±1% accuracy, fitted with a 1 m cable and a 2-pin 2.54 mm terminal. It is commonly used to measure temperature in 3D printer hotends and heated beds, and in general temperature sensing projects.
Specifications
- Resistance
- 100KΩ
- B value
- B3950
- Accuracy
- ±1%
- Cable length
- 1000 mm
- Connector
- 2-pin, 2.54 mm pitch
- Outer diameter
- 1.05 mm
- Temperature rating (as listed)
- 200 degrees / 300V
Frequently asked questions
What is the price of NTC 100K B3950 Thermistor 1% with 1m Cable and 2-Pin Connector in Egypt?
NTC 100K B3950 Thermistor 1% with 1m Cable and 2-Pin Connector currently costs 45 EGP in Egypt.
Where can I buy NTC 100K B3950 Thermistor 1% with 1m Cable and 2-Pin Connector in Egypt?
NTC 100K B3950 Thermistor 1% with 1m Cable and 2-Pin Connector is available from Microohm. Compare the offers above to find the best price.
How do I wire it to a 3D printer board?
Connect the two wires to the thermistor input and ground on the board. An NTC thermistor has no polarity, so either wire can go to either terminal. The firmware must be set to the 100K / B3950 table.
Does it need a pull-up resistor?
Yes, the thermistor forms a voltage divider with a fixed pull-up resistor on the controller board. Use the value your board specifies, commonly 4.7kΩ on many 3D printer boards.
