3D Printer NTC 100K Thermistor Sensor with 1 m Cable
Prices updated: 12 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 UGE | 3D Printer NTC 100K Sensor with 1M Cable | 50 EGP | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 50 EGP
About this product
An NTC thermistor with a nominal resistance of 100 kΩ and a B value of 3950, fitted in a glass-encapsulated head with Teflon-insulated leads. It is used to measure hotend and heated-bed temperature in 3D printers and other temperature control projects. Its rated operating range is -50 °C to +260 °C.
Specifications
- Nominal resistance
- 100 kΩ ±1%
- B value
- 3950 ±1%
- Operating temperature range
- -50 °C to +260 °C
- Material
- Teflon-insulated wire
- Thermistor head diameter
- 1.8 mm
- Thermal time constant
- 10–17 s (still air)
- Thermal dissipation constant
- 1.1–1.6 mW/°C
- Insulation resistance
- 50 MΩ or more at DC 500 V
Frequently asked questions
What is the price of 3D Printer NTC 100K Thermistor Sensor with 1 m Cable in Egypt?
3D Printer NTC 100K Thermistor Sensor with 1 m Cable currently costs 50 EGP in Egypt.
Where can I buy 3D Printer NTC 100K Thermistor Sensor with 1 m Cable in Egypt?
3D Printer NTC 100K Thermistor Sensor with 1 m Cable is available from UGE. Compare the offers above to find the best price.
How do I wire this thermistor to a 3D printer board?
NTC thermistors are not polarised, so either lead can go to the signal pin and the other to ground. Most boards use a pull-up resistor (commonly 4.7 kΩ) in the thermistor circuit, and the firmware needs the thermistor table that matches a 100K B3950 sensor.
Can it be used for hotend temperature control?
Yes, it is designed for this kind of use, with a rated range up to +260 °C. Make sure the firmware is configured for a 100K B3950 thermistor and that the sensor is placed in good thermal contact with the heater block.
