Mechanical Endstop Limit Switch Module for 3D Printers (RAMPS 1.4)
Prices updated: 13 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 Most Electronics | Mechanical Limit Switch Module | 32.9 EGP39.08 | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 32.9 EGP
About this product
A mechanical endstop limit switch module for 3D printers, designed to work with RAMPS 1.4 controller boards. It detects when an X, Y or Z axis reaches its minimum or maximum position: the moving carriage presses the switch lever to close the circuit, so no flags or light sensors are needed. Board size is approximately 39 x 16 x 7 mm.
Specifications
- Switch type
- Mechanical limit switch (endstop)
- Compatible controller
- RAMPS 1.4
- Application
- End detection for X/Y/Z axes of 3D printers
- Board size
- Approx. 39 x 16 x 7 mm
Frequently asked questions
What is the price of Mechanical Endstop Limit Switch Module for 3D Printers (RAMPS 1.4) in Egypt?
Mechanical Endstop Limit Switch Module for 3D Printers (RAMPS 1.4) currently costs 32.9 EGP in Egypt.
Where can I buy Mechanical Endstop Limit Switch Module for 3D Printers (RAMPS 1.4) in Egypt?
Mechanical Endstop Limit Switch Module for 3D Printers (RAMPS 1.4) is available from Most Electronics. Compare the offers above to find the best price.
Can I use this with controller boards other than RAMPS 1.4?
The listing specifies RAMPS 1.4. The module is a simple switch with signal and ground connections, so it can be wired to any controller with a digital endstop input. Check that your firmware's endstop logic (normally open or normally closed) matches how you wire it.
How do I wire it to the controller?
Connect the switch's signal and ground to the endstop input of the controller, typically the signal and GND pins of that axis' endstop header. Then set the firmware for the switch type you are using so the stop triggers correctly when the carriage reaches the end of travel.
