RAMPS 1.4 Arduino Mega Shield for RepRap 3D Printers (SKU 3D1000)
Prices updated: 13 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 RAM ElectronicsCheapest | RAMPS 1.4 RepRap 3D Printer Arduino Mega2560 Shield (SKU#3D1000) | 200 EGP | View in store |
 Most Electronics | RAMPS 1.4 Reprap 3D Printer Arduino Mega Shield (RAMPS) | 221 EGP275 | View in store |
 Microohm | 3D Printer Controller Board RAMPS 1.4 Arduino Mega Shield RepRap Prusa Model HIGH QUALITY | 240 EGP260 | View in store |
 Circuits Electronics | RAMPS 1.4 Reprap 3D Printer Arduino Mega Shield | 240 EGP | View in store |
Price history
Lowest daily price, last 90 days
Lowest price recorded: 200 EGP
About this product
A RAMPS 1.4 control shield that plugs onto an Arduino Mega 2560 to drive a RepRap-style 3D printer. It provides sockets for five stepper drivers, PWM MOSFET outputs for heaters and fans, thermistor inputs for two extruders and a heated bed, and endstop headers. It is a low-cost, open-source option that can be extended with Bluetooth or SD card add-ons.
Specifications
- Host board
- Arduino Mega 2560
- Stepper driver sockets
- 5 (StepStick type)
- MOSFET outputs
- 3, PWM controlled
- Thermistor circuits
- 3 (2 extruders, 1 heated bed)
- Heated bed fuse
- 11A
- Endstop header sets
- 6
- Extra broken-out pins
- PWM, digital, analog, serial, SPI, I2C
Frequently asked questions
What is the price of RAMPS 1.4 Arduino Mega Shield for RepRap 3D Printers (SKU 3D1000) in Egypt?
RAMPS 1.4 Arduino Mega Shield for RepRap 3D Printers (SKU 3D1000) currently costs between 200 and 240 EGP across 4 offers in Egypt.
Where can I buy RAMPS 1.4 Arduino Mega Shield for RepRap 3D Printers (SKU 3D1000) in Egypt?
RAMPS 1.4 Arduino Mega Shield for RepRap 3D Printers (SKU 3D1000) is available from RAM Electronics, Most Electronics, Microohm, and Circuits Electronics. Compare the offers above to find the best price.
What firmware does this shield run?
It is typically used with RepRap firmware such as Marlin, compiled for the RAMPS 1.4 board with an Arduino Mega 2560 target. The firmware configuration must match your printer's hardware, including the thermistor type and motor settings.
Do I need separate stepper drivers?
Yes. The shield has sockets for StepStick-type stepper drivers such as A4988 or DRV8825, which are plugged in separately. Make sure the driver orientation matches the socket markings and set the driver current before running the printer.
