Optical Endstop 5V for 3D Printers (Opto Endstop)
Prices updated: 12 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 RAM ElectronicsCheapest | 3D Printer Optical End Stop Switch Module For RAMPS (SKU#3D1004) | 45 EGP | View in store |
 Microohm | Optical Endstop Light Control Limit Optical Switch | 45 EGP95 | View in store |
 Future Electronics | Optical Endstop | 95 EGP | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 45 EGP
About this product
An optical endstop module with a slot that gives a digital output: when the light path is blocked, the output changes and an on-board LED lights up. It is used as a homing or end-of-travel sensor on 3D printers and CNC machines. It runs on 5 V DC and uses a standard electronic brick interface for plug-and-play connection.
Specifications
- Operating voltage
- DC 5 V
- Output
- digital, LED on when light is blocked
- Interface
- standard electronic brick
- Application
- homing and end-of-travel sensing
Frequently asked questions
What is the price of Optical Endstop 5V for 3D Printers (Opto Endstop) in Egypt?
Optical Endstop 5V for 3D Printers (Opto Endstop) currently costs between 45 and 95 EGP across 3 offers in Egypt.
Where can I buy Optical Endstop 5V for 3D Printers (Opto Endstop) in Egypt?
Optical Endstop 5V for 3D Printers (Opto Endstop) is available from RAM Electronics, Microohm, and Future Electronics. Compare the offers above to find the best price.
How do I wire it to a 3D printer board?
Connect the module to the endstop input of the controller board using the electronic brick connector, or wire VCC, GND and signal to the matching pins. The signal goes to the axis endstop input on the board.
The axis reports the wrong endstop state. What should I check?
Confirm the module reads as triggered when the slot is blocked, then adjust the endstop inversion setting in the printer firmware if the axis reports reversed states.
