ElectronicsEgypt
HM-10 BLE 4.0 Bluetooth Module (CC2541)

HM-10 BLE 4.0 Bluetooth Module (CC2541)

Part number: HM-10Bluetooth, WiFi, RF & LoRa

Lowest price now

345 EGP

3 offers · 3 stores

View in store: Makers Electronics

Prices updated: 12 Oct 2026

Compare prices

StorePriceView in store
Makers Electronics logoMakers ElectronicsCheapest345 EGPView in store
Microohm logoMicroohm350 EGP450View in store
RAM Electronics logoRAM Electronics350 EGPView in store

Price history

Lowest daily price, last 90 days

Not enough price history yet.

Lowest price recorded: 345 EGP

About this product

The HM-10 is a Bluetooth 4.0 Low Energy module built around the CC2541 chip, used to add wireless serial communication to microcontroller projects. It can be set as master or slave using AT commands, and its baud rate can be changed the same way. It is commonly paired with smartphones for sensor data, remote control and simple IoT prototypes.

Specifications

Bluetooth specification
4.0 BLE
Chip
CC2541
Operating frequency
2.4 GHz ISM band
Modulation
GFSK
Transmit power
≤ 4 dBm
Sensitivity
≤ -84 dBm at 0.1% BER
Operating mode
Master or Slave (set with AT commands)

Frequently asked questions

What is the price of HM-10 BLE 4.0 Bluetooth Module (CC2541) in Egypt?

HM-10 BLE 4.0 Bluetooth Module (CC2541) currently costs between 345 and 350 EGP across 3 offers in Egypt.

Where can I buy HM-10 BLE 4.0 Bluetooth Module (CC2541) in Egypt?

HM-10 BLE 4.0 Bluetooth Module (CC2541) is available from Makers Electronics, Microohm, and RAM Electronics. Compare the offers above to find the best price.

What is the default baud rate and how do I change it?

HM-10 modules are commonly shipped at 9600 baud. Confirm communication by sending AT, then use the AT+BAUD command to change the rate. Make sure your serial monitor uses the same rate.

Can I connect the HM-10 directly to a 5V Arduino?

The module logic level is 3.3V. Use a voltage divider or a level shifter on the signal line going into the module RX pin to avoid damaging it, while the module TX pin can usually be read directly by 5V boards.