ElectronicsEgypt
SW1801P Vibration Sensor Switch Module, 4-Pin, Adjustable Sensitivity

SW1801P Vibration Sensor Switch Module, 4-Pin, Adjustable Sensitivity

Lowest price now

30 EGP

2 offers · 2 storesSave up to 14%

View in store: Makers Electronics

Prices updated: 12 Oct 2026

Compare prices

StorePriceView in store
Makers Electronics logoMakers ElectronicsCheapest30 EGP35View in store
UGE logoUGE35 EGPView in store

Price history

Lowest daily price, last 90 days

Not enough price history yet.

Lowest price recorded: 30 EGP

About this product

SW1801P is a vibration and tilt sensor module that uses a ball-rolling switch instead of mercury, giving a digital output when movement or shaking is detected. An LM393 comparator stabilizes the output, an onboard potentiometer sets the trigger sensitivity, and power and status LEDs give visual feedback. It suits alarms, automation and robotics.

Specifications

Sensor type
Ball-rolling vibration / tilt switch (non-mercury)
Comparator
LM393
Output
Digital switching signal
Sensitivity adjustment
Onboard potentiometer
Indicators
Power LED and status LED
Pins
4

Frequently asked questions

What is the price of SW1801P Vibration Sensor Switch Module, 4-Pin, Adjustable Sensitivity in Egypt?

SW1801P Vibration Sensor Switch Module, 4-Pin, Adjustable Sensitivity currently costs between 30 and 35 EGP across 2 offers in Egypt.

Where can I buy SW1801P Vibration Sensor Switch Module, 4-Pin, Adjustable Sensitivity in Egypt?

SW1801P Vibration Sensor Switch Module, 4-Pin, Adjustable Sensitivity is available from Makers Electronics and UGE. Compare the offers above to find the best price.

How do I connect it to a microcontroller?

Connect power and ground, then read the digital output on a GPIO pin. The output polarity can vary between board versions, so check the silkscreen labels and confirm whether the signal is active high or active low.

How do I adjust the trigger sensitivity?

Turn the onboard potentiometer to change the comparator threshold. Adjust it slowly while shaking or tilting the module until the status LED responds at the level you need.