NEO-6M V2 GPS Module with Ceramic Active Antenna (GY-NEO6MV2)
Prices updated: 13 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 UGECheapest | NEO-6M V2 GPS Module with Ceramic Active Antenna | 490 EGP | View in store |
 Ekostra | NEO-6M GPS Module with EPROM | 500 EGP | View in store |
 Makers Electronics | Ublox NEO-6M GPS Module HW-539A11 | 565 EGP | View in store |
Price history
Lowest daily price, last 90 days
Lowest price recorded: 490 EGP
About this product
The NEO-6M V2 GPS module (GY-NEO6MV2) is a UART GPS receiver built around the u-blox NEO-6M chipset, with a ceramic active antenna. It runs from 3.0 to 5.0 V and outputs NMEA data at 9600 baud by default, so it suits both 3.3 V and 5 V boards. Commonly used with Arduino, ESP32 and location-tracking projects.
Specifications
- Chipset
- u-blox NEO-6M
- Supply voltage
- 3.0 – 5.0 V
- Interface
- UART (TTL), 9600 baud default
- Position accuracy
- ~2.5 – 5.0 m (2D)
- Update rate
- Up to 5 Hz
- Tracking sensitivity
- -161 dBm
- Module size
- ~36 x 26 x 5 mm
- Supported satellite systems
- GPS, SBAS (WAAS, EGNOS)
Frequently asked questions
What is the price of NEO-6M V2 GPS Module with Ceramic Active Antenna (GY-NEO6MV2) in Egypt?
NEO-6M V2 GPS Module with Ceramic Active Antenna (GY-NEO6MV2) currently costs between 490 and 565 EGP across 3 offers in Egypt.
Where can I buy NEO-6M V2 GPS Module with Ceramic Active Antenna (GY-NEO6MV2) in Egypt?
NEO-6M V2 GPS Module with Ceramic Active Antenna (GY-NEO6MV2) is available from UGE, Ekostra, and Makers Electronics. Compare the offers above to find the best price.
How do I wire the NEO-6M V2 to an Arduino?
Connect VCC to 5 V (or 3.3 V on 3.3 V boards), GND to GND, the module TX pin to a serial RX pin on the Arduino, and the module RX pin to a serial TX pin if you need to send configuration commands. Use a hardware serial port or SoftwareSerial at 9600 baud.
Why does the GPS take a long time to get a fix?
A GPS receiver needs a clear view of the sky and time to receive satellite signals. The first fix after power-up, called a cold start, can take several minutes. Place the ceramic antenna facing up, away from metal and walls, for the best results.
