MPU-6050 GY-521 6-DOF IMU Module (Gyro + Accelerometer)
Prices updated: 12 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 Makers ElectronicsCheapest | MPU-6050 IMU Sensor Module with 6 DOF (Gyroscope, Accelerometer) | 115 EGP | View in store |
 Microohm | MPU-6050 3-Axis Accelerometer and Gyro Sensor GY-521 | 125 EGP175 | View in store |
 UGE | GY-521 Gyroscope MPU6050 6 DOF IMU Module GY521 MPU-6050 | 175 EGP | View in store |
 RAM Electronics | IMU 6-DOF MPU-6050 Gyroscope + Accelerometer Sensor Module | 175 EGP | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 115 EGP
About this product
The MPU-6050 (GY-521 breakout) combines a 3-axis MEMS accelerometer and a 3-axis MEMS gyroscope in one chip, with 16-bit ADCs for each channel. It communicates over I2C and includes a Digital Motion Processor (DMP) to offload motion calculations from the host. It is widely used for balancing robots, motion tracking and drone projects.
Specifications
- Sensor Type
- 6-DOF: 3-axis accelerometer + 3-axis gyroscope
- ADC Resolution
- 16-bit per channel
- Interface
- I2C
- I2C Address
- 0x68 (default)
- Module Supply Voltage
- 3.3–5 V
- Built-in Processor
- Digital Motion Processor (DMP)
Frequently asked questions
What is the price of MPU-6050 GY-521 6-DOF IMU Module (Gyro + Accelerometer) in Egypt?
MPU-6050 GY-521 6-DOF IMU Module (Gyro + Accelerometer) currently costs between 115 and 175 EGP across 4 offers in Egypt.
Where can I buy MPU-6050 GY-521 6-DOF IMU Module (Gyro + Accelerometer) in Egypt?
MPU-6050 GY-521 6-DOF IMU Module (Gyro + Accelerometer) is available from Makers Electronics, Microohm, UGE, and RAM Electronics. Compare the offers above to find the best price.
How do I wire the GY-521 to an Arduino?
Connect VCC to 3.3 V or 5 V, GND to GND, SDA to the SDA pin (A4 on UNO) and SCL to the SCL pin (A5 on UNO). The default I2C address is 0x68, and pulling AD0 high changes it to 0x69.
Can I use the MPU-6050 with a 3.3 V microcontroller?
Yes. The module accepts 3.3 V supply and is commonly used with 3.3 V boards such as ESP32 and STM32. Make sure the SDA and SCL lines are at compatible logic levels with your board.
