IRF530N N-Channel Power MOSFET 100V TO-220
Prices updated: 13 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 Most ElectronicsCheapest | IRF530N N-Channel MOSFET (100V, 14A) | 13.99 EGP23.15 | View in store |
 RAM Electronics | IRF530N N-Channel MOSFET | 17 EGP | View in store |
 Ekostra | IRF530N N-Channel Power MOSFET 100V 17A 0.064 Ohm | 25 EGP | View in store |
 Future Electronics | IRF530N MOSFET (100V, 14A) | 35 EGP | View in store |
Price history
Lowest daily price, last 90 days
Lowest price recorded: 13.99 EGP
About this product
The IRF530N is an N-channel power MOSFET in a TO-220 package, rated for 100 V drain-source and about 17 A continuous current. It is used as a switch for motors, relays, lamps and LED loads in power-control and DIY circuits. It is not a logic-level device, so it needs an adequate gate drive voltage.
Specifications
- Channel type
- N-channel
- Drain-source voltage (VDS)
- 100 V
- Continuous drain current (ID)
- 17 A
- RDS(on) max at VGS = 10 V
- 0.09 Ω
- Gate threshold voltage (VGS(th))
- 2 V to 4 V
- Package
- TO-220AB
Frequently asked questions
What is the price of IRF530N N-Channel Power MOSFET 100V TO-220 in Egypt?
IRF530N N-Channel Power MOSFET 100V TO-220 currently costs between 13.99 and 35 EGP across 4 offers in Egypt.
Where can I buy IRF530N N-Channel Power MOSFET 100V TO-220 in Egypt?
IRF530N N-Channel Power MOSFET 100V TO-220 is available from Most Electronics, RAM Electronics, Ekostra, and Future Electronics. Compare the offers above to find the best price.
Can I drive the IRF530N directly from a 5V Arduino or 3.3V ESP32 pin?
Not reliably. Its threshold is 2 to 4 V and full-on performance needs about 10 V on the gate, so a 3.3 V or 5 V GPIO will leave it partly on and overheating. Use a logic-level MOSFET or a gate driver stage instead.
What is the basic wiring for switching a load?
For a low-side switch, connect the load between the positive supply and the drain, the source to ground, and the MCU pin to the gate through a resistor of about 100 Ω. Add a 10 kΩ pull-down from gate to source so the MOSFET stays off at boot. Add a flyback diode across inductive loads such as motors or relays.
