ElectronicsEgypt
BC550 NPN Bipolar Junction Transistor (TO-92)

BC550 NPN Bipolar Junction Transistor (TO-92)

Part number: BC550Transistors & MOSFETs

Lowest price now

1 EGP

2 offers · 2 storesSave up to 50%

View in store: Makers Electronics

Prices updated: 12 Oct 2026

Compare prices

StorePriceView in store
Makers Electronics logoMakers ElectronicsCheapest1 EGPView in store
Future Electronics logoFuture Electronics2 EGPView in store

Price history

Lowest daily price, last 90 days

Not enough price history yet.

Lowest price recorded: 1 EGP

About this product

The BC550 is a low-noise NPN silicon bipolar transistor in a TO-92 package, intended for small-signal amplification and switching. It is commonly used in low-current hobby circuits, such as signal stages and switching loads up to 100 mA. Check the pin order in the datasheet before wiring, because TO-92 pinouts can differ by manufacturer.

Specifications

Transistor type
NPN bipolar junction transistor
Package
TO-92
Collector-emitter voltage (VCEO)
45 V
Maximum collector current (IC)
100 mA
Noise performance
Low-noise
Typical use
Small-signal amplification and switching

Frequently asked questions

What is the price of BC550 NPN Bipolar Junction Transistor (TO-92) in Egypt?

BC550 NPN Bipolar Junction Transistor (TO-92) currently costs between 1 and 2 EGP across 2 offers in Egypt.

Where can I buy BC550 NPN Bipolar Junction Transistor (TO-92) in Egypt?

BC550 NPN Bipolar Junction Transistor (TO-92) is available from Makers Electronics and Future Electronics. Compare the offers above to find the best price.

Can the BC550 switch a relay or a motor?

Only small loads within its 100 mA collector current rating. For larger relays or motors, use a transistor or driver rated for that current, and add a flyback diode across inductive loads.

How do I wire the BC550 as a switch for an LED or a microcontroller pin?

Connect the load between the collector and the supply, the emitter to ground, and drive the base through a resistor from the microcontroller pin. Confirm the terminal order in the datasheet before soldering.