24V 70W Ceramic Cartridge Heater 6x20mm for 3D Printer Hotend
Currently unavailable
No store has this product in stock right now. Prices below are the last ones we recorded.
Prices updated: 14 Oct 2026
Price history
Lowest daily price, last 90 days
Not enough price history yet.
About this product
A 24 V, 70 W ceramic cartridge heater, 6 mm in diameter and 20 mm long, with 80 to 100 cm lead wires. It is designed to fit the heater bore of a 3D printer hotend block. The long leads make routing from the hotend to the control board easier.
Specifications
- Voltage
- 24 V / 24 فولت
- Power
- 70 W / 70 واط
- Core material
- Ceramic / سيراميك
- Diameter
- 6 mm / 6 مم
- Length
- 20 mm / 20 مم
- Lead wire length
- 80 to 100 cm / من 80 إلى 100 سم
Frequently asked questions
Will this heater fit my hotend block?
Check that the heater bore is 6 mm in diameter and at least 20 mm long, so the cartridge seats fully. The heater must also match the voltage supplied by your printer's heater output.
Can I run this 24 V heater from a 12 V supply?
It is rated for 24 V, so a 12 V supply will deliver much less power and heat up slowly. Use a supply and heater output that match the 24 V rating.
