XH2.54 2-Pin 10 cm Jumper Cable, Female Housing, Tinned End
Currently unavailable
No store has this product in stock right now. Prices below are the last ones we recorded.
Prices updated: 14 Oct 2026
Price history
Lowest daily price, last 90 days
Not enough price history yet.
About this product
A 10 cm, 2-pin XH2.54 jumper cable with a female housing on one end and a tinned wire end on the other for soldering. It is commonly used on 3D printer boards to connect heaters, fans, endstops and other peripherals. The 2.54 mm pitch must match the mating header.
Specifications
- Length
- 10 cm
- Number of pins
- 2
- Pitch
- 2.54 mm
- Connector end
- Female housing
- Other end
- Tinned for soldering
Frequently asked questions
Is it compatible with JST-XH connectors?
Check the pitch before mating. This cable is listed at 2.54 mm pitch, while standard JST XH connectors are 2.50 mm. Confirm the pitch of your board header with a caliper or the datasheet before connecting.
How should I finish the bare tinned end?
Tin the wire and solder it to the terminal or pad with a suitable iron. Use heat-shrink tubing or insulation over the joint to prevent shorts.
