USBasp USB In-Circuit Programmer for Atmel AVR (ATmega8-based)
Prices updated: 12 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 Makers ElectronicsCheapest | HW-437 USB ASP AVR Programmer | 120 EGP | View in store |
 Future Electronics | USBASP AVR Programmer | 145 EGP | View in store |
 Microohm | ASP USB Programmer for AVR Microcontrollers | 160 EGP220 | View in store |
 RAM Electronics | ATMEL AVR USBasp Programmer - China | 175 EGP | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 120 EGP
About this product
USBasp is a low-cost USB in-circuit programmer for Atmel AVR microcontrollers, based on Thomas Fischl's open USBasp design. An ATmega8 handles the USB interface and the rest is done in firmware. It works with avrdude on Linux and macOS without a driver, while Windows Vista and newer need a USBasp driver.
Specifications
- Interface
- USB
- Target devices
- Atmel AVR microcontrollers
- USB interface MCU
- ATmega8
- Software
- avrdude (Linux, macOS)
- Windows support
- Vista and later, with USBasp driver
Frequently asked questions
What is the price of USBasp USB In-Circuit Programmer for Atmel AVR (ATmega8-based) in Egypt?
USBasp USB In-Circuit Programmer for Atmel AVR (ATmega8-based) currently costs between 120 and 175 EGP across 4 offers in Egypt.
Where can I buy USBasp USB In-Circuit Programmer for Atmel AVR (ATmega8-based) in Egypt?
USBasp USB In-Circuit Programmer for Atmel AVR (ATmega8-based) is available from Makers Electronics, Future Electronics, Microohm, and RAM Electronics. Compare the offers above to find the best price.
How do I program an ATmega328P with USBasp?
On Linux or macOS, run avrdude with -c usbasp and -p m328p, plus your flash write option, for example -U flash:w:file.hex:i. On Windows, install the USBasp driver first.
How do I wire USBasp to a target board?
Connect the 10-pin ISP header to the target's ISP pins: MOSI, MISO, SCK, RESET, VCC and GND. Use a 10-to-6-pin adapter for 6-pin targets. Some boards have a jumper for target voltage, so check it before connecting a 3.3 V target.
