ElectronicsEgypt
TL072CN Dual Operational Amplifier IC DIP-8

TL072CN Dual Operational Amplifier IC DIP-8

Part number: TL072CNIntegrated Circuits (ICs)

Lowest price now

8 EGP

3 offers · 3 storesSave up to 53%

View in store: Microohm

Prices updated: 12 Oct 2026

Compare prices

StorePriceView in store
Microohm logoMicroohmCheapest8 EGP11View in store
Makers Electronics logoMakers Electronics8 EGPView in store
RAM Electronics logoRAM Electronics17 EGPView in store

Price history

Lowest daily price, last 90 days

Not enough price history yet.

Lowest price recorded: 8 EGP

About this product

TL072CN is a dual JFET-input operational amplifier in an 8-pin DIP package, containing two independent amplifiers in one chip. It is widely used in audio preamplifiers, active filters, buffers and signal conditioning circuits thanks to its low noise, low distortion and wide supply range. It is a common general-purpose op-amp for hobby and student projects.

Specifications

Amplifiers per package
2 (dual)
Package
DIP-8
Input type
JFET
Supply voltage
±18 V (6 V to 36 V total)
Quiescent current
1.4 mA to 2.5 mA
Output current
10 mA
Output short-circuit protection
Yes

Frequently asked questions

What is the price of TL072CN Dual Operational Amplifier IC DIP-8 in Egypt?

TL072CN Dual Operational Amplifier IC DIP-8 currently costs between 8 and 17 EGP across 3 offers in Egypt.

Where can I buy TL072CN Dual Operational Amplifier IC DIP-8 in Egypt?

TL072CN Dual Operational Amplifier IC DIP-8 is available from Microohm, Makers Electronics, and RAM Electronics. Compare the offers above to find the best price.

What is the TL072 pinout?

Pin 1 is output A, pin 2 is inverting input A, pin 3 is non-inverting input A, pin 4 is V- (negative supply or ground in single-supply use), pin 5 is non-inverting input B, pin 6 is inverting input B, pin 7 is output B, and pin 8 is V+.

Can TL072 run from a single supply?

Yes, it can run from a single positive supply within its 6 V to 36 V total range. Its output does not swing fully to the rails, so biasing the signal around mid-supply is recommended.