ST-LINK V2 Programmer and Debugger for STM8 and STM32 (SWD/SWIM)
Prices updated: 12 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 Makers ElectronicsCheapest | ST-LINK V2 Emulator and Debugger/Programmer for STM8 and STM32 | 140 EGP | View in store |
 Microohm | ST Link V2 Programmer For STM8 and STM32 High Quality | 220 EGP350 | View in store |
 RAM Electronics | ST-Link V2 Programming For STM8 & STM32 Emulator | 225 EGP | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 140 EGP
About this product
ST-LINK V2 is a USB programmer and debugger for STM32 microcontrollers over SWD and for STM8 devices over SWIM. This version is listed as fully compatible with the official ST-LINK V2 and supports both 5 V and 3.3 V target voltages. It works with IDEs such as STM32CubeIDE to flash firmware and debug code on your boards.
Specifications
- Supported MCUs
- STM32 (SWD), STM8 (SWIM)
- Host connection
- USB
- Target voltage
- 5 V and 3.3 V
- Onboard protection
- 500 mA resettable fuse
- Housing
- Aluminum alloy, laser-engraved labels
Frequently asked questions
What is the price of ST-LINK V2 Programmer and Debugger for STM8 and STM32 (SWD/SWIM) in Egypt?
ST-LINK V2 Programmer and Debugger for STM8 and STM32 (SWD/SWIM) currently costs between 140 and 225 EGP across 3 offers in Egypt.
Where can I buy ST-LINK V2 Programmer and Debugger for STM8 and STM32 (SWD/SWIM) in Egypt?
ST-LINK V2 Programmer and Debugger for STM8 and STM32 (SWD/SWIM) is available from Makers Electronics, Microohm, and RAM Electronics. Compare the offers above to find the best price.
Which pins do I connect to an STM32 board?
For SWD, connect SWDIO, SWCLK and GND to the target, and connect the 3.3 V or 5 V pin if the target is not powered from its own supply. For STM8 SWIM programming, connect SWIM, RST and GND instead.
Should I connect the power pin from ST-LINK to my target board?
Only if the target board has no power supply of its own. If the board is already powered, connect just the data pins and GND, and make sure both boards share a common ground.
