Mini 4-Pin Tactile Push Button 6x6x4.3mm (PCB Mount)
Prices updated: 12 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 Makers Electronics | Mini Push button 4-pin 6x6x4.3mm | 0.75 EGP | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 0.75 EGP
About this product
A miniature 4-pin momentary tactile push button in a 6×6 mm footprint with a 4.3 mm body height, designed for PCB mounting. It is used as a manual input in low-power electronic projects such as menus, reset buttons and mode selection on microcontroller boards. The contacts close only while the button is pressed and open again on release.
Specifications
- Number of pins
- 4
- Body size
- 6 × 6 mm
- Height
- 4.3 mm
- Switch type
- Momentary tactile push button
- Mounting
- PCB mount
Frequently asked questions
What is the price of Mini 4-Pin Tactile Push Button 6x6x4.3mm (PCB Mount) in Egypt?
Mini 4-Pin Tactile Push Button 6x6x4.3mm (PCB Mount) currently costs 0.75 EGP in Egypt.
Where can I buy Mini 4-Pin Tactile Push Button 6x6x4.3mm (PCB Mount) in Egypt?
Mini 4-Pin Tactile Push Button 6x6x4.3mm (PCB Mount) is available from Makers Electronics. Compare the offers above to find the best price.
How do I wire a 4-pin tactile switch?
The two pins on each side of the switch are internally connected. Connect one pin from one side to the microcontroller input and a pin from the opposite side to GND. Use an internal or external pull-up resistor on the input so it reads high when the button is released.
Does the switch need debouncing?
Yes. Mechanical tactile switches produce a short burst of contact bounce when pressed. A software delay of roughly 10 to 20 ms or a simple RC filter on the input is usually enough to get a clean single press.
