HLK-PM12 3W AC-DC Power Module, 220VAC to 12VDC
Prices updated: 13 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 RAM ElectronicsCheapest | AC-DC Module 3W 220Vac to 12Vdc (HLK-PM12) | 115 EGP | View in store |
 Makers Electronics | HLK-PM12 AC/DC Power Module 12V 0.25A 3W | 160 EGP | View in store |
 Microohm | Hi-link HLK PM12 12V/3W Switch Power Supply Module | 170 EGP230 | View in store |
 Future Electronics | 220Vac to 12Vdc 3W Ultra-Compact Power Module (HLK-PM12) | 200 EGP | View in store |
Price history
Lowest daily price, last 90 days
Lowest price recorded: 115 EGP
About this product
The HLK-PM12 is an ultra-compact AC-DC power module from Hi-Link that converts a 100–240 VAC mains input into a regulated 12 VDC output rated at about 3 W (250 mA continuous). It is intended for embedding in enclosures to power small 12 V circuits, relays and control electronics.
Specifications
- Input voltage
- 100–240 VAC (rated), 90–264 VAC range
- Output voltage
- 12 VDC
- Output current
- 250 mA continuous, 350 mA short-term
- Output power
- 3 W
- Output ripple and noise
- ≤70 mVp-p
- MTBF
- ≥100,000 h
Frequently asked questions
What is the price of HLK-PM12 3W AC-DC Power Module, 220VAC to 12VDC in Egypt?
HLK-PM12 3W AC-DC Power Module, 220VAC to 12VDC currently costs between 115 and 200 EGP across 4 offers in Egypt.
Where can I buy HLK-PM12 3W AC-DC Power Module, 220VAC to 12VDC in Egypt?
HLK-PM12 3W AC-DC Power Module, 220VAC to 12VDC is available from RAM Electronics, Makers Electronics, Microohm, and Future Electronics. Compare the offers above to find the best price.
Is the HLK-PM12 safe for beginners to use?
The input is connected directly to mains voltage. Disconnect power before wiring, use an insulated enclosure, keep mains wiring separate from low-voltage wiring, and never touch the module while it is powered.
Can the 12 V output power an Arduino or ESP board?
The 12 V output can feed the VIN pin of boards that accept a 7–12 V input, such as the Arduino Uno, for loads well below 250 mA. Boards that need 5 V or 3.3 V should go through a buck converter or regulator.
