BMP280 Barometric Pressure and Altitude Sensor Module (I2C/SPI)
Prices updated: 13 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 EkostraCheapest | GY-BMP280-3.3 Precision Altimeter Atmospheric Pressure BMP280 Sensor Module | 70 EGP | View in store |
 Most Electronics | BMP280 Barometric Pressure and Altitude Sensor I2C/SPI Module 5V | 90 EGP129 | View in store |
 Circuits Electronics | BMP280 Barometric Pressure and Altitude Sensor I2C/SPI Module 5V | 135 EGP | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 70 EGP
About this product
The BMP280 module uses Bosch's BMP280 sensor to measure barometric pressure and temperature, and the pressure reading can be used to estimate altitude. It communicates over I2C or SPI and is commonly used in weather stations, altimeters, indoor navigation and environmental monitoring projects with Arduino, ESP32 or Raspberry Pi boards.
Specifications
- Pressure measurement range
- 300 to 1100 hPa
- Pressure accuracy
- ±1.0 hPa (absolute)
- Temperature range
- -40 to +85 °C
- Digital interfaces
- I2C (up to 3.4 MHz), SPI 3/4-wire (up to 10 MHz)
- Supply voltage
- 3.3 V to 5 V DC
- Peak current
- 1.12 mA
Frequently asked questions
What is the price of BMP280 Barometric Pressure and Altitude Sensor Module (I2C/SPI) in Egypt?
BMP280 Barometric Pressure and Altitude Sensor Module (I2C/SPI) currently costs between 70 and 135 EGP across 3 offers in Egypt.
Where can I buy BMP280 Barometric Pressure and Altitude Sensor Module (I2C/SPI) in Egypt?
BMP280 Barometric Pressure and Altitude Sensor Module (I2C/SPI) is available from Ekostra, Most Electronics, and Circuits Electronics. Compare the offers above to find the best price.
What is the default I2C address of the BMP280 module?
The BMP280 uses address 0x76 when the SDO pin is low and 0x77 when SDO is high. Check the SDO wiring on your module before scanning the I2C bus.
Can I power the module from a 5 V Arduino?
Yes, the module lists a 3.3 V to 5 V supply range. Make sure the I2C or SPI lines are at the logic level your board expects.
