BC556 PNP Bipolar Transistor 65V 0.1A TO-92
Prices updated: 13 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 Makers ElectronicsCheapest | BC556 Bipolar Transistor | 0.75 EGP | View in store |
 Most Electronics | BC556 Transistor (65V, 0.1A) | 0.78 EGP0.9 | View in store |
 Microohm | BC556 PNP Transistor | 1 EGP2 | View in store |
 Future Electronics | BC556 Transistor (65V, 0.1A) | 2 EGP | View in store |
 Circuits Electronics | BC556 (65V, 0.1A) | 2 EGP | View in store |
Price history
Lowest daily price, last 90 days
Lowest price recorded: 0.75 EGP
About this product
The BC556 is a PNP general-purpose bipolar transistor in a TO-92 plastic package. It is used for switching and small-signal amplification in low-power circuits, such as driving LEDs or small loads through a suitable driver stage.
Specifications
- Transistor type
- PNP
- Collector-emitter voltage (VCEO)
- -65 V
- Collector-base voltage (VCBO)
- -80 V
- Emitter-base voltage (VEBO)
- -5 V
- Collector current (IC)
- -0.1 A
- Collector dissipation (Pc)
- 0.625 W
- Transition frequency (fT)
- 150 MHz
- Package
- TO-92
Frequently asked questions
What is the price of BC556 PNP Bipolar Transistor 65V 0.1A TO-92 in Egypt?
BC556 PNP Bipolar Transistor 65V 0.1A TO-92 currently costs between 0.75 and 2 EGP across 5 offers in Egypt.
Where can I buy BC556 PNP Bipolar Transistor 65V 0.1A TO-92 in Egypt?
BC556 PNP Bipolar Transistor 65V 0.1A TO-92 is available from Makers Electronics, Most Electronics, Microohm, Future Electronics, and Circuits Electronics. Compare the offers above to find the best price.
What is the pinout of the BC556?
In TO-92 form the listed pinout is pin 1 Collector, pin 2 Base and pin 3 Emitter. Confirm the orientation against the datasheet of your specific manufacturer before soldering, since pin arrangements are read from the flat side of the case.
Can I use the BC556 to switch a load from a 5 V circuit?
Yes, as a PNP switch with the emitter on the positive supply and the load on the collector. Its maximum collector current is 0.1 A, so keep the load current below that value and use a base resistor to limit base current from the controlling pin.
