5V Breadboard Power Module with 7805 Regulator and DC Input
Prices updated: 12 Oct 2026
Compare prices
| Store | product | Price | View in store |
|---|---|---|---|
 MicroohmCheapest | 5V Kit DC Input Voltage to Breadboard | 28 EGP46 | View in store |
 RAM Electronics | Kit DC Input Voltage to Breadboard | 35 EGP | View in store |
Price history
Lowest daily price, last 90 days
Not enough price history yet.
Lowest price recorded: 28 EGP
About this product
This breadboard power kit takes a DC input and provides a regulated 5 V output through a 7805 linear regulator, so it can power breadboard circuits, microcontrollers and logic from a higher-voltage supply. It suits prototyping and learning projects. A linear regulator dissipates the excess voltage as heat, so keep the input close to the required minimum.
Specifications
- Output voltage
- 5 V
- Regulator IC
- 7805 (linear, fixed 5 V)
- Input type
- DC
- Minimum input for regulation (7805 datasheet)
- About 7 V
- Maximum input voltage (7805 datasheet)
- 35 V
Frequently asked questions
What is the price of 5V Breadboard Power Module with 7805 Regulator and DC Input in Egypt?
5V Breadboard Power Module with 7805 Regulator and DC Input currently costs between 28 and 35 EGP across 2 offers in Egypt.
Where can I buy 5V Breadboard Power Module with 7805 Regulator and DC Input in Egypt?
5V Breadboard Power Module with 7805 Regulator and DC Input is available from Microohm and RAM Electronics. Compare the offers above to find the best price.
What input voltage should I supply?
The 7805 needs roughly 7 V or more to hold a 5 V output, and its datasheet maximum is 35 V. Use an input in that window, closer to the lower end to limit heat. The specifications do not state the module's own input range, so check the board markings.
How do I wire it to a breadboard?
Connect the positive of the DC supply to the input terminal and the negative to GND. Take the 5 V and GND outputs to the breadboard power rails, and connect the grounds of all circuits together. Confirm the terminal labels printed on the board before connecting.
